I have a 2005 Bolens 38" twin blade riding mower. It was running and I went to engage the blades and the pulleys were seized. The mower stalled as expected. I took the deck out and changed the blade spindles, blades, etc. I have a full charge on my battery and checked both the PTO switch and the park brake switch, seat switch, and solenoid, all have continuity, but I have no power at all. The fuse 20amp fuse to the ignition is good as well as the power going to the starter. Any ideas?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
Make sure you have the blade clutch disengaged
I seem to have same issue the carb has one those electric solinoid? I have tried the disengaging of the blades. Even took bracket lose so I cud pull handle back a little farther tested ignition switch seems to have power started right up n ran like a champ after I dipped carb turned it off and 2 minutes later its like a wire lose its like I have no power between battery n engine or its that stupid blade disengament set up crap totally frustrated would trully appreciate your help
Sorry to hear you are having issues! I learned the hard way on things like this to go right to the experts so as not to muck things up worse (I have so this is from experience).
The company contact info is: www.mtdproducts.com/
Hope they have a super easy solution for you! Let us know what they say!
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
