How do I make a slot in the top of a glass block to make a bank. And how do you smooth the edges after drilling?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
Drilling glass blocks.
Step 1
You have to use the right rpm range, there should be something on the side of your drill listing the rpm.
Step 2
Gradually increase speed and slowly decrease.
Step 3
Use a carbide bit especially for glass.
Step 4
Tape a small piece of cardboard to the glass block so it doesn't slip.
Step 5
Place light pressure on the drill.
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
