With half the work done, this Dollar Tree pumpkin gets an upgrade! I hope you like it.
Advertisement
Total Time: 30 minutes
Yield: 1
Supplies:
1 Dollar Tree pumpkin
36 in ribbon
4 faux flowers
scissors
hot glue gun
Steps:
The Dollar Tree has a new line of pumpkins, that are covered with a velvet'ish coating. They are yummy, but of course, can be better.
Remove the stem, or leave it on. I found it was so hard to take off it almost ruined it, so unless you were going to replace it, leave it on.
Trim the stems off the flowers and then hot glue them on. If your flowers are bigger, 3 might be best.
Advertisement
I glued the green ribbon onto the top, under one of the flower petals. Then, ran it around the groove and glued it to the other side. Once those were done, it's time to admire your work! N-JOY!!
With half the work done, this Dollar Tree pumpkin gets an upgrade! I hope you like it.
