I replaced my circuit board since the "learn" button had been broken off and now I can't get my hard-wired wall switch to work. The remotes have been programmed and work fine, but the wall switch won't open or close the door. I can't find how to reprogram the wall switch, which is what I think I need to do.
By Lance
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
Well I don't know if this will be of any help but Overhead Door Company also owns Genie so maybe contacting them at www.overheaddoor.com may be able to answer your question. I have Overhead doors and the manual only tells one how to reprogram the remote controls. Under trouble shooting the only solutions they have if the wall control does not run is,
1. Check lock switch on wall console.
2. Check power source.
Plug a lamp into the outlet used for power head. If lamp works,power source is OK. If not check fuses or circuit breaker
If power is OK
Check connections at power head terminals
Check connections at wall control
Motor protector may be open. Wait about 20 minutes for protector to reset.
Not much but that is all my manual has to say.
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!