Get Gorilla Glue, you can find it anywhere. Get a piece of fabric like a T-shirt. Cut it into small squares. Deflate the air mattress in this process and know where your pinhole is! Put Gorilla Glue on the felt and then on the fabric. Push it on to the hole. Then get a hair dryer, keep a little far away on warm for 2 minutes. Let it dry 3 to 4 hours. Fill your bed up and it's done.
Hope I helped someone, good luck!
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
Please add more detail to your description. You mention pieces of a T-shirt, then you mention felt. I assume your mattress is made with a felt surface. Mine is vinyl. You do not say how many pieces of the T-shirt fabric to use, whether to stack them, and how to arrange them in regard to the hole.
i also do not see you saying felt. my mattress has a huge bubble so it looks like a sofa. im scared to try to tAKE IT DOWN to try to take air out. sleeping on the fl0or is ok
I used paper towel, cut up 2 small squares about an inch wide by an inch long, first make sure your air matress is deflated, locate the hole, put gorilla glue over the hole, slather 1 small square of paper towel with gorilla glue, put it on top of the hole with the glue on it, then repeat the process with the next piece. Heat up the patch with light heat from a blower dryer, wipe any excess glue and keep flatting the glue out of it any wiping it. Let it set for an hour or two and your golden. I weigh 240lbs i inflated my air matress and laid on it. No leaks at all!
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
