Intertwined Bead and Wire Crochet Bracelet

Total Time: 3 Hours

Supplies:

• thin copper wire 0.1 mm from an old transformer
• seed beads
• 7-8 pearlescent beads with a diameter of 8 mm
• 1 clasp hook and circle
• 1 crochet hook 1.5 mm
• 1 scissors

Steps:

1. String a lot of seed beads onto the wire.

 
2. Slip knot, * slide in one seed bead, 1 chain stitch. Repeat from * 29 times.

 

 

 
3. Slip stitch to form a ring.

 
4. 1st round: slide in one seed bead, 1 chain stitch. Crochet it in every stitch.

 
Advertisement


5. 2nd round: slide in one seed bead, 1 chain stitch. Crochet it in every stitch.
   Finish of crochet. Cut wire. First crochet beaded ring is ready.
   

 
6. Crochet 6-8 beaded rings - repeat the steps 1-5. The number of rings depends on the length of the bracelet.

 
7. Connect the rings as in the photos.

 

 

 
8. Crochet a chain of 15 beads. Fold the large ring and thread the crocheted chain through it. Slip stitch to form ring.

 

 
Advertisement


9. Crochet two rounds like in the steps 4 and 5.

 

 
10. Fold the wire several times and tie to a clasp circle. Then tie it to the extreme crocheted beaded ring. Twist the ends of wires.

 

 

 
11. * String a mother-of-pearl bead. Then wrap the wire around next crocheted beaded ring. Thread 7 seed beads and wrap the wire around next crocheted beaded ring. Repeat from * until you wrap the wire around the opposite end of the bracelet.

 

 

 

 

 
Advertisement


12. Wrap the wire around the clasp hook several times and tie it. Cut the wire and hide the end.
    

 

 

Your Crochet Beaded Bracelet is ready. Enjoy it!