We used a very expensive latex paint that contained a primer over oil paint, to paint kitchen cabinets.
Now the paint is pealing. Is there a solution?
By Diane from Ipswich, MA
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
The reason your latex paint is peeling is because your oil base enameled surface couldn't accept the latex even though the latex contained primer.
You're going to need to scrape off the peeling latex, then properly prepare the enameled surface, which is accomplished by removing the oil based enamel using a stripper, or scraping or sanding the enamel coating off-completely. Any little bit of the enamel will cause the new paint to blister and peel so be sure to get it ALL.
After you've got the previous oil based enamel off, apply a separate, good quality primer-be sure to read the label carefully before buying. It should say that it is to be used on surfaces that have had oil based paints removed in preparation for application of a latex one.
It sounds fiddly but it is the only way to get a long-lasting, attractive finish.
The previous poster is correct. Alternately, you could remove the latex completely, and then lightly sand, prime and paint with oil based paint again. But you can't put latex over oil without a lot of work, which you have just learned.
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!