After you have tried tightening all the screws, and checking to see if the blades are warped and they are not, most likely, the blade arm(s) are bent slightly. I tried everything, but this is how I finally solved the wobbling issue:
Some have suggested to measure the blades from the ceiling and then bend the arms back while still on the fan. Do NOT do this. You will most likely make the issue worse. Take the blades off the fan and take the blade arms off the blades. Since each arm has a purposeful slight twist in them, lay the arms on the table and hold down the bases flat on that table. Then measure the distance of the twisted edges from the tabletop. If one or more do not match and are off, then use a crescent wrench on the base to bend them slightly back. Measurements must be precise! Down to the 16th of an inch! Because if the bend on a blade arm is off by just 1 degree, the blade end will be off by a lot. This is the "only" thing that worked for me to get my fan balanced. Good luck!
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!