Recycled Cork Thread Dispenser and a Candle Holder

Sandi/Poor But Proud
Gold Post Medal for All Time! 969 Posts

Total Time: 60 Minues

Yield: 2

Supplies:

• mini embroidery hoop ($0.25)
• 8 wine corks
• hot glue
• steak knife
• 1 peanut butter jar lid
• 1 small wooden thread spool ($0.05)
• embroidery hoop ($0.25)
• 8 wine corks ($0.10)
• 1 mini mason jar ($0.50)
• 1 candle ($0.10)
• paring knife
• 16 in ribbon and lace (optional) ($0.15)
• button (optional) ($0.15)

Steps:

1. I didn't think about the spool until the craft was half done, so there is no shot of it in the supplies. But for this project, I was able to use both the inner and outer rings of the hoop. It took 8 corks total. More on that in a few. I was trying to force 9 in there and that is when I took out the center two, and it hit me. "I bet a small spool of thread would fit in there". And it took some doing to find the right size, but I did.

 
Advertisement


2. The spool sits up on a cork that has been cut in half.

 
3. When you have the smaller spools, it really is amazing how cool it is to not have it roll all over the table.
4. For the final step, I found a peanut butter lid that fit so perfectly on it that it was like the two were meant to work together. You can glue it if you like, then flip it over, or just fit the corks down in it. Or you can leave it off. I used it so it would slide a bit easier on my work table.

 
5. For the candle holder, it was pretty much the same thing, but with a small jar in the center instead.
Advertisement


6. Sadly, I had glued the corks around the jar before I realized the candle wouldn't set inside. I had to carve it down some and wish now I had used a faux candle, but live and learn I guess. I glued the corks around the jar and added the finishing touches. I wanted it to be a bit prettier so I put some lace and ribbon around it, adding a snail button.

 

 

 

 

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!