I have a Hyundai Getz. My windscreen washer has water running to it and the pump is working off the side jet, but I need to know how to remove the near side jet and I assume replace? Anybody know how it is connected to the bonnet as I looked and found no easy catches to release?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
Try pin/needle in jet holes.If this does not help puul off tubing;it takes some effort sometimes,be careful.Then try washers.If water comes out of tube ,blockade in jets.Otherwise its from tank up that tube?Pull off and blow through etc.If water flows then jets blocked.To remove squeeze the plastic clips together..this can be hard due to poor access thro hole in bonnet,but can be done.When removed wash in hot soapy water and poke all holes (3) thro..two top and tube inlet one.This should do it and also blow them hard by air pump (and mouth)etc til clear;may take time!To replace just pus them back till the plastic clips snap back to grip jet piece.Take care of them as I have not been able to find replacements anywhere! Good luck and keep water tank clean and clear...use no additives.
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
