lalala...
Gold Post Medal for All Time! 899 Posts 
If you are looking for a fun and easy decoration to make for St. Patrick's day, why not make this wreath. Scrap wreaths are so easy to make and are a great way to use up small pieces of fabric.
Total Time: 2-3 hours
Supplies:
- 2-3 red scraps (approx. 1/4 yard each)
- 1-2 orange scraps (approx. 1/4 yard each)
- 1-2 yellow scraps (approx. 1/4 yard each)
- 2-3 green scraps (approx. 1/2 yard each)
- 2-3 blue scraps (approx. 1/4 yard each)
- 2-3 purple scraps (approx. 1/4 yard each)
- white scraps (approx. 1/2 yard)
- black felt (stiff is best)
- gold felt
- yellow buttons
- wire wreath form
- rotary cutter and rotary pinking blade, or pinking shears
- cutting mat, optional
- large acrylic ruler, optional
- hot glue gun
- wire (approx. 5 in.)
Click here to download a template for making the pot of gold.
Steps:
- Using a pinking blade cut all colors into strips (9 in. x 1 in.). Make sure that all edges are cut with the pinking blade. This will help prevent the fabric from fraying.
- Secure the strips onto the wreath form, by folding the strip in half, bringing the edges under the wire, then bring them over the top of the wire tucking them into the loop of the fabric, and pulling tightly to secure.
- The wreath form I used only had 4 wires, so I decided to do reds on the outside wire, alternate orange and yellow on the second wire, then blues and greens on the third, and purples on the last wire. Attach all the fabric scraps in this way until you have created an arched rainbow shape on the wire form.
- At the ends of the rainbow, attach white scraps to create clouds.
- Finish filling in the wreath at the bottom with green scraps to create grass.
- To create the pot of gold, print out the attached template and cut out the template pieces. Using a white colored pencil, trace around the template pieces for the pot onto the back of the black felt. Cut them out and set aside. Trace the gold template onto the gold felt using a black pen. Cut out and set aside.
- Using a hot glue gun attach the gold piece onto the front of the black pot. Then attach the two pot accent pieces, the large one at the top, just covering the end of the gold. The smaller piece goes at the bottom. These will give the pot some dimension.
- Hot glue a few yellow buttons onto the gold felt, for dimension too.
- On the back of the pot, hot glue a short piece of wire. I chose to cut a small square of felt and glue that over the middle of the wire for added strength.
- Finally, attach the pot of gold, using the wire, onto the wreath. Hang it up and enjoy!
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
February 17, 20130 found this helpful
I love this idea!
February 17, 20130 found this helpful
This also gives me some ideas for using the plastic and wire fan grates from old fans that have broken. Love the idea so much~:)
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
