social

Swiffer WetJet Nozzle Holes Won't Spray?

I moped over some hot oil with my swifer wer jet. Now liquid will not spray through nozzle. Can the metal mesh holes melt? Mope still works,lights still work but liquid is backing up at the nozzle end and trying to squeeze through. Can I fix this or do o need to replace mop?

Advertisement

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

August 25, 20230 found this helpful

Mine were stopped up also. I sprayed the nozzles thick with a Lysol Cleaner. I used Kitchen Lysol but any of them should work. Leave it soaking for 15 to 20 minutes. I used toothpicks and pulled what I could from the nozzles, then I held the bottom part of the Swiffer Wet Jet in the bathtub under hot running water. Don't get water in the motor area. These steps cleaned mine right up, including the nozzles.

Reply Was this helpful? Yes

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

Categories
Home and Garden Cleaning ProductsAugust 23, 2023
Pages
More
🐛
Pest Control
🌻
Gardening
📓
Back to School Ideas!
Facebook
Pinterest
YouTube
Instagram
Contests!
Newsletters
Ask a Question
Share a Post
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2023-08-25 13:11:19 in 2 secs. ⛅️️
© 1997-2023 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/Swiffer-WetJet-Nozzle-Holes-Wont-Spray.html